Wall alignment for wallpaper
Wallpaper is a fairly popular and sought–after type of coating. They are cheap (though it depends on which ones), beautiful and easy to glue. But in order for everything to go smoothly and simply, and the wallpaper to "sit" well on the walls, it is necessary to make the walls smooth and smooth, ruthlessly getting rid of all kinds of bumps, roughness and hollows.
There are two ways to align walls to wallpaper. The first is using sheets of drywall. The second is the use of building mixes.
Wall alignment for wallpaper: drywall
Plasterboard sheets are attached to the wall on special profiles, the location of which is adjusted according to the vertical level. This method allows you to get an almost perfectly flat surface. To adjust the profiles, it is enough to loosen or tighten their fastenings.
Usually 12.5 mm thick sheets are used for wall decoration. The sizes of the sheets themselves can be different. It all depends on the manufacturer. PP 60 profiles and 12.5 cm staples are purchased for them.
When you have installed all the drywall sheets in place, simply seal all the seams between them. To do this, first of all it is necessary to glue them with a paint grid, and then seal them with putty. After that, in order to finally level the surface, it is recommended to apply another thin layer of putty on it. This surface is perfect for gluing wallpaper on it.
Wall alignment for wallpaper: building mixes
If you decide to use building mixes to level the walls, you will need to study several nuances related to this process. So, in houses and apartments, walls can be divided into load-bearing and partitions. The former are usually made of either brick or concrete. Their integrity should not be violated, as this threatens to collapse the entire structure.
Partition walls are made of gypsum slabs or bricks, then covered with plaster. You can align the surface of the walls using a special "beacon", which is a pointer made of soft metal. Such beacons must be placed in the corners of the room, stretch a nylon thread and make a plumb line. Thus, you can get a beacon line along which the solution will be applied. Apply mortar to the building rule, attach it to the lighthouses, and fill the space between it and the wall with mortar. After the solution dries, you can continue working. When the walls become smooth, the plaster will need to be prepared for wallpaper: primed with special glue. Mostbet BD https://mostbet-bangladesh.biz – Online Casino, Sports Betting in Bangladesh.
